23
COMPUTER INPUT
SELECTING COMPUTER SYSTEM
This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to
“COMPATIBLE COMPUTER SPECIFICATIONS” on page 24). When a computer input is selected, the projector
automatically tunes to the incoming signal and projects the proper image without any special setting. (Some computers may
need to be set up manually.)
Note : Projector may display one of the following messages.
When the projector cannot recognize the PC signal as a
system programmed into the projector, the Auto PC
Adjustment function attempts to adjust the projector and
the message “Auto” is displayed on the SYSTEM Menu
icon. (Refer to P25.) If the image is not displayed
properly, manual adjustment is required. (Refer to P26
and 27.)
There is no signal input from computer. Make sure the
computer and projector are connected and configured
properly.
(Refer to TROUBLESHOOTING on page 42.)
Auto
––––
SYSTEM Menu icon
Displays system being
selected.
PC SYSTEM MENU
SELECT COMPUTER SYSTEM MANUALLY
SYSTEM Menu icon
Displays system being selected.
The systems on this dialog box
can be selected.
Press MENU and ON-SCREEN MENU will appear. Press POINT
LEFT/RIGHT to move the red frame pointer to PC SYSTEM.
Press POINT DOWN to move the red arrow pointer to the
system that you want to set, and then press
SELECT.
1
2
PC SYSTEM MENU
Custom Mode (1~5) set in PC
ADJUST Menu. (P26, 27)
This projector automatically selects PC system among those provided
in this projector. The PC system can be also selected manually.
When a digital computer signal is received on the DVI
terminal, one of the above messages will be displayed on
the PC SYSTEM Menu icon.
D-VGA, D-SVGA or D-XGA
Komentáře k této Příručce